Rivera Primo Mid-Controls - Manual (Page 8)

8. Remove block-off cap from outer belt guard. (Photo 10A & 10B)
If your outer belt guard does not have a block-off cap
you will have to finish machining the shifter crossover
tube hole. (Photo 10C)
9. Install the outer belt guard per BRUTE IV EXTREME TM
instructions.
10. Install thrust washer (P/N 1101-0022) over shifter shaft.
(Photo 11)
11. Install shifter yoke onto shifter shaft aligning the
three(3) each dowel pins on the shaft to the yoke
using one(1) each 5/16-18 x 1.00” socket head cap
screw to pull the yoke onto the shifter shaft and torque.
(Photo 12)
12. Install footpeg and shifter peg.
13. Reinstall the battery.
Photo 10A
Photo 10B Photo 10C
Photo 11
Photo 12
1101-0022
Shifter Lever Assy