Silverline Air Narrow Crown Stapler 22mm - Manual (Page 6)

www.silverlinetools.com
5
Air Narrow Crown Stapler 22mm 771422
Air Tool Safety
Dangerous environment
• Always ensure there is adequate clear space around the work area. Only
use spraying tools in a well ventilated area or a specialist spray booth. Be
aware that air hoses can present a trip hazard; always lay hoses in a way
that minimises hazards
Protection from vibration
• Hand-held air tools may produce vibration and should not be used for
long periods without a break. Vibration can cause disease. Gloves may
help to maintain good blood circulation in the fingers.
Maintain your air tool
• Ensure that you keep air tools clean and lubricated. Lubrication is
essential to prevent corrosion of internal parts, which could lead to
machine failure
Always disconnect
• Always ensure the air tool is switched OFF before connecting to air
supply. Be aware that air tools may hold residual pressure after use.
Always bleed air pressure from the tool after shutting off air supply
• Ensure fasteners are correctly fitted before reconnecting to the air supply
• Disconnect an air tool from the air supply before inserting fasteners,
attachments or performing any servicing
• Always ensure that your air tool has fully stopped functioning before
putting it down
Use the correct air hose
• Use a correctly rated air hose appropriate to the compressor and this
product
Protective equipment
• Wear appropriate safety equipment, including eye, ear and hand
protection
Use of air staplers/nailers
• Do not aim this tool at people or animals
• Always wear appropriate protective equipment including but not limited
to overalls, gloves, etc
• It is the user’s responsibility to ensure that any other persons in
the vicinity of the work area are also equipped with the appropriate
protective equipment
Do not abuse the machine
• Do not overload the machine. Allowing the machine to work at its
optimum speed is safer and prolongs its service life
• Do not increase air pressure above the recommended level; excessive
pressure leads to wear of moving parts, possible failure and may cause
the machine casing to split
• Do not attempt to modify air tools. Any attempt to modify this air tool
could result in serious injury to you or others, and will invalidate its
warranty
1 Trigger
2 Air Inlet / 1 ⁄
4
" BSP Quick Connector
3 Bottle of Air Tool Oil
4 Magazine Latch
5 Magazine Cover
6 Safety Catch
7 Hex Keys
8 Screws
Product Familiarisation