Atari 040-0050-01 - Manual (Page 3)

Preface
© 2004 GLOBAL VR
®
, INC.
040-0050-01
Rev. A 10/29/2004
Page 3 of 48
Preface
Safety
Please read this page before preparing your arcade cabinet for game play.
The following safety instructions apply to all game operators and service personnel. Specific
warnings and cautions will be included throughout this manual.
Use the following safety guidelines to help protect the system from potential damage and to
ensure your personal safety:
• Make sure that the switch on the back of the computer is set to match the AC power in
use at your location:
115 volts / 60Hz in most of North and South America and some Far Eastern countries
such as Japan, South Korea and Taiwan
230 volts / 50Hz in most of Europe, the Middle East and the Far East
• To help prevent electric shock, plug the system into a properly grounded power source.
The cables are equipped with 3-prong plugs to help ensure proper grounding. Do not use
adapter plugs or remove the grounding prong from a cable. If you must use an extension
cable, use a 3-wire cable with properly grounded plugs.
• To help protect your system from sudden increases and decreases in electrical power, use
a surge suppressor, line conditioner, or Uninterruptible Power Supply (UPS).
• Be sure nothing rests on the system's cables and that the cables are not located where they
can be stepped on or tripped over.
• Do not spill food or liquid on the cabinet.
• Do not push any objects into the openings of the system—doing so can cause fire or
electric shock by shorting out interior components.
• Keep your system far away from radiators and other heat sources.
• Do not block cooling vents.
Warnings
To avoid electrical shock, unplug the cabinet before performing the
installation procedures.
GLOBAL VR
®
assumes no liability for any damages or injuries incurred while
setting up or servicing the cabinet. Only qualified service personnel should
perform installation or service procedures!
Environmental Conditions
Cabinet is intended for indoor use only. Be sure to keep the cabinet dry and maintain
operating temperatures of 10°-40°C (50°-104°F).