Atari 040-0050-01 User Manual
Page 7
Section 2 – Cabinet Conversion
© 2004 GLOBAL VR
®
, INC.
040-0050-01
Rev. A 10/29/2004
Page 7 of 48
Remove old Tournament Header and Card Reader
If your cabinet has an existing tournament header or card reader, these components can be
removed. They are not used by the gvrSX™ system.
The card reader is usually located near the coin door. The header is usually located at the top
of the cabinet. Perform the following steps to remove the card reader and tournament header:
1. Unplug the data cables from the card reader and remove them from the cabinet.
2. Un-bolt the card reader and use the same carriage bolts to install a card reader blank plate
(not provided).
3. Unplug the cables from the tournament header and remove them from the cabinet.
4. Un-bolt the tournament header and remove it from the cabinet.