AT&T 9110 - Manual (Page 2)

INSTALLATION
• Place the handset battery pack
in the compartment. Make sure
the metal contacts on the
underside of the battery are
aligned with the charging
contacts in the handset battery
compartment.
• Replace the handset battery
cover by sliding it on its track
up and over the handset battery
compartment until it snaps
firmly in place.
6 Charge the handset batteries
before use.
Place the handset in the base unit
cradle either in the face up or face
down position. Make sure that the
IN USE/CHARGE light on the
base is on. The handset battery
must be charged a minimum of
6 hours before using your phone
for the first time. The batteries
recharge automatically whenever
the handset is placed in the base
unit cradle.
7 Check for dial tone.
After the batteries are charged,
pick up the handset and press
. The PHONE indicator
should light up, and you should
hear a dial tone. If not, see “IN
CASE OF DIFFICULTY" in this
manual.
1 Setting up the Cordless
Telephone 9110.
• Choose an area near an electri-
cal outlet and a telephone jack.
• The outlet should not be
controlled by a wall switch.
2 Connect the telephone line cord.
• Insert one end of the telephone
line cord into the jack at the
rear of the base unit. Plug the
other end into a telephone jack.
Make sure the plugs snap
securely into place.
3 Connect the power cord.
• Plug the AC power adapter into
a standard electrical outlet and
the DC connector into the
power jack located at the
rear of the base unit.
• Wrap the power cord around the
strain relief hook on the bottom
of the base unit (see illustration).
The strain relief hook helps
protect the power cord from
accidentally being removed.
CAUTION: Use only the AC power
adapter supplied with this telephone.
This is a Class 2 AC adapter, specifi-
cally designed for use with the 9110.
NOTE: Connect power to the base
unit before placing the handset in
the cradle.
4 Set the dial mode switch.
If you have touch tone service on
your phone line, set the switch
located on the bottom of the base
to TONE. If you have rotary
service, set the switch to PULSE.
5 Install the handset battery.
• Remove the handset battery
cover by pressing the
indentation on the handset
battery cover and sliding the
cover downward.
Standard power outlet Power cord
Power jack
Telephone jack Telephone line cord
Telephone jack
Base unit
Reversible base
Thicker end
Strain relief hook
Slots
Slots
Tabs
Clips
1