Hints and tips, Ecological hints, Water hardness and conductivity – AEG LAVATHERM 65270AC EN User Manual

Page 13: Water container full — indication

Advertising
background image

HINTS AND TIPS

ECOLOGICAL HINTS

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry
becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible small
pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Use the load volumes specified in the

programmes chapter.

• Make sure that is good airflow in the

appliance installation position.

• Clean the filter after each drying cycle.
• Spin good the laundry before drying.

WATER HARDNESS AND

CONDUCTIVITY

Water hardness can be different for differ-
ent locations. Water hardness has an ef-
fect on the water conductivity and the op-
eration of the conductivity sensor in the
appliance. If you know the value of the
water conductivity you can adjust the sen-
sor to dry with the better results.
To change the sensor conductivity:

1.

Turn the programme dial to available
programme.

2.

Push at the same time the Delicate
and Anticrease buttons and hold
down until one of the these symbols
go into view on the display:

low conductivity <300 μS/

cm

moderate conductivity

300-600 μS/cm

high conductivity >600 μS/

cm

3.

Push the Start Pause button again
and again until you set necessary lev-
el.

4.

To memorise setting push at the
same time the Delicate and Anti-
crease buttons.

WATER CONTAINER FULL —

INDICATION

By default the indication LED is always on.
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:

1.

Turn the programme dial to available
programme.

2.

Push at the same time the Delicate
and Delay Start buttons and hold
down until you see the correct set-
ting:
– the LED is off and the symbol

goes into the view - The

LED is permanently off

– the LED is on and the symbol

goes into the view - The

LED is activated

ENGLISH

13

Advertising
This manual is related to the following products: