AEG LAVATHERM 65270AC EN - Manual (Page 19)

TROUBLESHOOTING
TROUBLESHOOTING
Problem
1) Possible cause Remedy
The tumble
dryer does
not operate.
The tumble dryer is not connec-
ted to mains supply.
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
The loading door is opened. Close the loading door.
The On/Off button was not
pushed.
Push the On/Off button.
The Start/Pause button was not
pushed.
Push the Start/Pause button.
The appliance is in the standby
mode.
Push the On/Off button.
Unsatisfac-
tory drying
results.
Incorrect programme selection.
Do the selection of the applica-
ble programme.
2)
The filter is clogged. Clean the filter.
3)
The condenser is clogged. Clean the condenser.
3)
Too high volume of the load.
Obey the maximum load vol-
ume.
The airflow grill is clogged.
Clean the airflow grill in the bot-
tom of the appliance.
Dirt on the inner surface of the
drum. Clean the inner surface of the
drum.
Too high water hardness. Set applicable water hardness
4)
.
The door
does not
close.
The filter not locked in the posi-
tion. Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal. Put the load correctly in the
drum.
Err (Error)
on the dis-
play.
You try to change the pro-
gramme or the function after
the start of the cycle.
Turn the tumble dryer off and
on. Make the new selection.
The function you try to activate
is not applicable with the selec-
ted programme.
Turn the tumble dryer off and
on. Make the new selection.
Abnormally
elapsing
time on the
display.
)
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The automatic procedure — this
is not the appliance malfunction.
Programme
inactive.
The water container is full.
Drain the water container
3)
,
push the Start/Pause button.
ENGLISH
19