AEG LAVATHERM 65270AC EN - Manual (Page 22)

INSTALLATION
APPLIANCE POSITIONING
• The tumble dryer must be installed in a
clean position, where dirt does not col-
lect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance are
not blocked .
• To keep vibration and noise at the mini-
mum, when the tumble dryer operates,
it must be put on a stable and flat sur-
face.
• When the appliance is put in its perma-
nent position, check if is fully level with
the aid of a spirit level. If it is not, adjust
the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through thick
carpets, bar of wood or equivalent. This
can increase the heat which can cause
interference with the operation of the
appliance.
• The temperature of the hot air
which occurs in the tumble dry-
er can increase to 60 °C. The
appliance must not be installed
on the floor which is not resist-
ant to high temperatures.
• When the tumble dryer oper-
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
• If it is necessary to move the ap-
pliance, it must be moved verti-
cally.
• The appliance must not be in-
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
UNPACKING
CAUTION!
Before use all parts of the transport pack-
aging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
INSTALLATION UNDER A
COUNTER
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
22 www.aeg.com