Kramer Electronics VM-24H - Manual (Page 16)

VM-24H - Operating the VM-24H 13
To cycle between the different modes (One Output, Default and Auto-mix), as
defined in the following table, press the EDID SELECT button.
Current
EDID Mode Appearance To cycle to the
Default EDID To cycle to
the Auto-
mix EDID To cycle to the
One output EDID
One Output The selected
output LED
flashes Press the EDID
SELECT button
once again after
selecting output 4.
The output LEDS
flash
Default The output
LEDs flash
simultaneously Press the
EDID
SELECT
button once
Auto-mix All the output
LEDs light Press the EDID
SELECT button to
select the required
output. The
selected output
flashes
To acquire or change the EDID of a new output display from:

One output, see section
‎6.3.1

The default EDID, see section ‎6.3.2

Several connected outputs, see section ‎6.3.3
6.3.1 Acquiring / Changing the EDID from One Output
To acquire or change the EDID of one of the output displays:
1. Connect the power supply.
2. Connect the new output display device.
3. Press the EDID SELECT button, enter the One output mode as defined in
the previous table, and set to the connected output.
The appropriate OUTPUT STATUS LED flashes, indicating that that output
channel is selected.
4. Press the EDID READ button to copy the EDID of the selected OUTPUT to
the inputs.
If you want to cancel the EDID modification, wait for a few seconds without touching
any button