Kramer Electronics VP-28 - Manual (Page 10)

Figure 1: VP-28 Presentation Switcher Front Panel
# Feature Function
1
IR
LED Indicator Lights yellow when receiving IR signals
2 Sensor Receives the IR signal
3 POWER Switch Illuminated switch for turning on the power to the device
4 DVI Input Selection Buttons Press one of the three buttons to select the DVI input
5 HDMI Selection Buttons Press one of the three buttons to select the HDMI input
6 DP Selection Buttons Press one of the two buttons to select the DP input
7 HDMI+DP Button Press to combine/separate the HDMI and DP inputs into a single group (see Section 6.1 )
8 MASTER AUDIO SEL Button Press to select the Master audio channel (see Section 6.2 )
9 TALK OVER Button Press to select the MIC input as the primary audio feed and to lower the background Master audio level (toggle)
10 LOCK Button Press and hold to lock the front panel buttons. Press and hold again to unlock the buttons
11 MASTER VOLUME Knob Turn to adjust the master audio level
12 MIC VOLUME Knob Turn to adjust the microphone audio level
13 MIC IN 6.5mm Microphone Jack Connect a microphone. Note: Only one microphone can be connected at a time
14 PC Selection Buttons Press one of the three buttons to select the PC graphics input
15 CV Selection Buttons Press one of the three buttons to select the CV input
16 MUTE Button Press to mute/unmute the Master audio output
17 MIX Button Press to mix the microphone and Master audio output (toggle)
18 MIC SELECT
Button
COND Depress the button to select a condenser type microphone
DYN Release the button to select a dynamic type microphone
6
VP
-28
–
O
ver
view