Kramer Electronics VP-747 - Manual (Page 10)

8 VP-747 Control Software - Defining the Control Software
Menu Sub Menu 1 Sub Menu 2 Description
Auto Image Assesses the image and improves the
quality accordingly, by automatically
adjusting the phase, frequency and
position. Upon completion, the relevant
OSD values are updated (H-Position,
V-Position, Phase and Frequency)
Output Image
Properties
Output gamma Adjust the gamma: Gamma 1, 2, 3
Film mode Set the film mode: Auto, Video, Film
Temporal NR Set the temporal noise reduction level:
Off, Low, Medium, High
Mosquito NR Set the Mosquito noise reduction level:
Off, Low, Medium, High
Block NR Set the block noise reduction level: Off,
On
Detail enhancement Set the detail enhancement: Off, Low,
Medium, High If the USB input is
selected, Detail Enhancement is set to
Off
Luma transition
enhance
Set the luminance transition enhance
level: Off, Low, High
Chroma transition
enhance
Set the chrominance transition enhance
level: Off, Low, High
Brightness Adjust the brightness: 0 to 100
Contrast Adjust the contrast: 0 to 100
Color Adjust the color: 0 to 100
Hue Adjust the hue: 0 to 360
Sharpness 0-100
HQV Color Settings Red, green, blue, cyan, magenta,
yellow: -100 to +100
Scale Properties Aspect Ratio Set the aspect ratio:
Best Fit: The best possible compromise
between the input and the output aspect
ratios without distorting or cropping the
picture
Letterbox
Follow Output: Scales the picture to fill
the entire output screen
When the input and output aspect ratios
are the same, the only available option
is Follow Output. (The HQV considers
resolution 1920x1200 as 16:9)
Virtual Wide
Follow Input: Shows the picture
without scaling it (pixel-to-pixel
mapping)
Custom
H-Pan Horizontal pan: -16 to 16
Available when selecting Custom
aspect ratio
V-Pan Vertical pan: -16 to 16
Available when selecting Custom
aspect ratio
H-Zoom Horizontal zoom: -8 to 8
Available when selecting Custom
aspect ratio