Kramer Electronics VP-8x8TP - Manual (Page 20)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting and Configuring the VP-8x8TP 8x8 UXGA/Audio Matrix Switcher
16
Figure 8: Device Properties Window
5. Make the required changes.
6. Click Set to save changes, or click Close to exit without saving the changes.
6.5 Operating the VP-8x8TP 8x8 UXGA/Audio Matrix Switcher Remotely
You can operate the VP-8x8TP remotely via RS-232, RS-485, and/or Ethernet
using the Kramer K-Router application.
If you are operating a standalone unit via RS-232 or the Ethernet, configure the
unit as Machine number 1 (see
Section 6.2.2 ).
6.6 Setting the Switching Delay Time
You can achieve clean transitions when switching between non-genlocked sources
by setting the delay time—ranging from 0sec to 3.5sec
1
To set the delay time:
. The factory default delay
is 0 seconds.
1. Press the VIDEO and AUDIO front panel buttons simultaneously.
The 7-segment display shows the current switching delay time.
2. Use the + and – front panel buttons to set the delay time as required.
3. To exit the Delay mode, press the TAKE front panel button.
1 In increments of 0.5sec