Kramer Electronics VS-1616D - Manual (Page 27)

Operating Your Video Matrix Switcher
23
23
7.4.3 Turning an Output Off
Turning an output off means that there is no input switched to this output. This is
indicated on the display by the Input being blank underneath the relevant Output.
To turn an output off:
1. Press MENU.
The Menu buttons light and are enabled.
2. Press OFF (3) on the numeric keypad (see Figure 2 ).
The following message is displayed:
out__ => OFF
3. Use the numeric keypad to turn the required output off.
The output is turned off.
To turn an output off in the Confirm mode:
• Repeat the steps above and then press the flashing TAKE button to confirm
the action
Alternatively, you can perform a switching operation (see Section 7.4.1
7.4.4 Turning Off Several Outputs
) and set
the input to 00.
To turn off several outputs in the Confirm mode, repeat the switching actions
described in Section 7.4.2
7.4.5 Recalling the Default Setup
but set the inputs to 00.
You can store a commonly used setup as the default setup (see Section 8.2.8
Note: This is not the setup that is loaded when the unit is turned on. When the unit
is turned on, the setup that was last used before the unit was turned off is loaded.
)
which can be recalled at any time.
To recall the default setup:
1. Press DEFAULT SETUP.
The DEFAULT SETUP button flashes and the following message is
displayed:
recall DEFAULT setup
press FLASHING button to confirm
2. Press DEFAULT SETUP.
The following message is displayed:
all Setups and Connections change
press TAKE to confirm
• The TAKE button flashes.
3. Press TAKE.
The default setup is recalled and the display reverts to the output-input
display.