Kramer Electronics VS-3232DN User Manual
User manual
Advertising
Table of contents
Document Outline
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Defining the VS-3232DN 32x32 Digital Matrix Switcher
- 5 Installing in a Rack
- 6 Connecting the VS-3232DN
- 7 Operating Your Video Matrix Switcher
- 8 Using the Configuration Menus
- 8.1 Using the Setup Menu
- 8.1.1 Setup Menu—1: inXX=>ALL, Switching one Input to all Outputs
- 8.1.2 Setup Menu—3: outXX=>OFF, Turning an Output Off
- 8.1.3 Setup Menu—7: EDID, Assignment to an Input
- 8.1.4 Setup Menu—9: Delay, Setting for an Output
- 8.1.5 Setup Menu—4: store setup XX, Storing the Setup in a Preset
- 8.1.6 Setup Menu—6: recall setup XX, Recalling a Preset
- 8.2 Using the Config Menu
- 8.2.1 Config Menu—Input Signal Detection Display
- 8.2.2 Config Menu—Input Port Parameter Setting
- 8.2.3 Config Menu—Output Load Detection Display
- 8.2.4 Config Menu—Output Port Parameter Setting
- 8.2.5 Config Menu—Interface Configuration
- 8.2.6 Config Menu—Interface Reply Configuration
- 8.2.7 Config Menu—Protocol Configuration
- 8.2.8 Config Menu—Store Default Setup
- 8.2.9 Config Menu—Total Matrix Reset
- 8.2.10 Config Menu—Display Firmware Versions
- 8.1 Using the Setup Menu
- 9 Configuring the Number of Installed Input and Output Ports
- 10 Installing and Using the Test Module to Troubleshoot Video Problems
- 11 Hardware Installation Instructions
- 12 Upgrading the VS-3232DN Firmware
- 13 Technical Specifications
- 14 Default Communication Parameters
- 15 Factory Default EDID
- 16 Communication Protocols