8 using the configuration menus, 1 using the setup menu, Using the configuration menus – Kramer Electronics VS-3232DN User Manual

Page 30: Using the setup menu, On 8, 8using the configuration menus

Advertising
background image

26

VS-3232DN - Using the Configuration Menus

8

Using the Configuration Menus

The configuration menus let you configure the VS-3232DN to best suit your needs.

There are two configuration menus:

•

Setup Menu—those that are accessed on a regular basis (for example,

storing setups and setting the delay), see

Section 8.1

•

Config Menu—those that are accessed only occasionally (for example,

setting the interface or communication protocol), see

Section 8.2

The following rules apply to the menu operation:

•

If no selection is made within approximately 15 seconds, the operation

times-out and the display reverts to the output/input display

•

At any point in the Menu, press ESC to move up one level or press

BREAKAWAY to exit the Menu altogether

•

At any point in the Menu, only buttons that are active light or flash

•

All of the procedures in this section assume that you are starting the

procedure from the standard, operational output/input display

8.1

Using the Setup Menu

The Setup Menu provides access to settings that are regularly changed and

comprises the following options:

•

1: inXX=>ALL, switching one input to all outputs (see

Section 8.1.1

•

3: outXX=OFF, turning off an output (see

)

Section 8.1.2

•

7: EDID, assignment to an output (see

)

Section 8.1.3

•

9: Delay setting for an output (see

)

Section 8.1.4

•

4: store setup XX, storing the setup in a preset (see

)

Section 8.1.5

•

6: recall setup XX, recalling a preset (see

)

Section 8.1.6

)



Advertising