Kramer Electronics VS-42HN - Manual (Page 20)

VS-42HN - Operating the VS-42HN 4x2 HDMI Matrix Switcher 17
Figure 7: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
6.6.2 Connecting the Ethernet Port via a Network Hub
You can connect the Ethernet port of the VS-42HN to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
6.6.3 Control Configuration via the Ethernet Port
To control several units via the Ethernet, connect the Master unit (Machine # 1) via
the Ethernet port to the LAN port of your PC. Use your PC initially to configure the
settings (see Section 6.4 ).
6.7 Upgrading the Firmware
For instructions on upgrading the firmware see “Upgrading the VS-42HN Firmware
Using the STC Software ”.