Kramer Electronics VS-88DTP - Manual (Page 23)

VS-88DTP - Operating the VS-88DTP 19
6.3 Storing and Recalling Setups in Presets
You can use the STO and RCL buttons to store and recall up to 16 setups in
presets.
Figure 9 illustrates the preset assignment numbers. Preset 1 is assigned
to OUT 1 and preset 16 is assigned to IN 8.
Note: The preset numbers do not appear on the buttons.
Figure 9: Preset Number Assignments using the Selector Buttons
To store a setup:
1. Route inputs and outputs as required.
2. Press the STO button.
The STO button flashes.
3. Select a preset number in which to store the current configuration (for
example, for preset 13, press IN 5).
To recall a setup:
1. Press the RCL button.
The RCL button flashes.
2. Press the required preset button (for example, for preset 13, press
IN 5).
6.4 Switching Between Protocol 2000 and Protocol 3000
To switch to Protocol 2000:
• Press the Output 1 and Output 2 buttons at the same time.
The device switches to Protocol 2000 and the display shows 2000
To switch to Protocol 3000:
• Press the Output 1 and Output 3 buttons at the same time.
The device switches to Protocol 3000 and the display shows 3000