Kramer Electronics FC-24ETH - Manual (Page 38)

34 Configuring and Maintaining the FC-21ETH,
FC-22ETH and FC-24ETH
8.3 Activating DHCP
The IP address of the FC-21ETH, FC-22ETH and FC-24ETH can be set either
statically or dynamically where it is issued by a DHCP server.
To activate and deactivate DHCP:
1. Press the DHCP button on the front panel.
DHCP is activated, the DHCP LED lights green.
2. Press the DHCP button again.
DHCP is deactivated and the DHCP LED no longer lights.
8.4 Resetting to the Factory Default Settings
To reset the device to its factory default settings:
1. Turn off the power to the device.
2. Press and hold the Reset button on the front panel.
3. Turn on the power to the device while holding down the Reset button for a
few seconds.
4. Release the button.
The device is reset to the factory default settings.
8.5 Upgrading the Firmware
For
instructions on upgrading the firmware see the “Kramer K-Upload User
Manual ”.