Kramer Electronics RC-3TBU - Manual (Page 20)

SL-14RC/N - Installing and Using RC-3TBU Configurator Software 17
9 Installing and Using RC-3TBU Configurator
Software
Before installing the RC-3TBU Configurator Software you must install the latest
version of the Kramer USB driver. Instructions for doing so can be found in the
Kramer USB Driver Installation Guide.
The latest version of the RC-3TBU Configurator Software and the Kramer USB
driver can be downloaded from http://www.kramerelectronics.com .
Note: The RC-3TBU does not need to be connected to a power supply in order to
use the software to configure the device. Power to the RC-3TBU is provided by via
the USB connection.
9.1 Installing the RC-3TBU Configurator Software
To install the RC-3TBU Configurator Software:
1. Download the latest version of the software from
http://www.kramerelectronics.com .
2. Run the Setup.exe file and follow the instructions to install the software to
the required location.
9.2 Using the RC-3TBU Configurator Software
To use the RC-3TBU Configurator Software:
1. Run the software by clicking on the icon.
The Kramer RC-3TBU Configurator window appears.
2. Click on the Connect button.
The Connection Method window appears as shown in Figure 9 .