Kramer Electronics Tavor 5-O - Manual (Page 11)

SPK-WA511 - Installing the Speakers 7
7
5 Installing the Speakers
This section explains how to:
• Choose the best location for your speakers (see Section 5.1 )
• Install the speaker wires (see Section 5.2 )
5.1 Choosing the Best Location
Before installing the speakers:
• Experiment by placing the speakers in different locations before finally
deciding on the most suitable location
• Be sure that the wall type is appropriate for the mounting brackets, that is,
either solid wood, bricks, concrete, hollow building blocks, or wood studs.
You cannot mount the brackets on gypsum walls
• Check that the mounting location is free of obstructions, such as electrical
piping, AC ducts or water lines, and so on
5.2 Installing the Speaker Wires
To install the speakers, do the following:
1. Connect the + and - stereo sockets of the active speaker to the + and -
stereo sockets of the passive speaker using the cable supplied, as follows:
Figure 4: Connecting the Active Speaker to the Passive Speaker
Active Speaker (L) Passive Speaker (R)