Kramer Electronics FC-4046 - Manual (Page 4)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your FC-4046 Video MultiCoder®
2
In addition, the FC-4046:
Includes analog inputs and outputs compatible with the formats and
standards in use today
Is highly automated for hassle-free operation
Includes user-friendly front panel buttons for full Procamp control
Labels each dipswitch for easy and convenient identification
Automatically recognizes the input video standards
1 : PAL B/D/G/H/I,
NTSC3.58 and SECAM
Can output PAL B/D/G/H/I/Nc/60 and NTSC3.58/4.43 2
Has CV, YC and component 3 inputs and outputs
Simultaneously outputs to CV, YC and component (RGB or YUV)
formats
Can be used as a multi-format switcher, always converting to all the
formats
Includes non-volatile memory that retains the last setting, after switching
the power off and then on again
Is controllable via the front panel buttons, and/or remotely by RS-232
serial commands transmitted by a touch screen system, PC, or other serial
controller
To achieve the best performance:
Connect only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
Avoid interference from neighboring electrical appliances that may
adversely influence signal quality
Position your Kramer FC-4046 in a location free from moisture and away
from excessive sunlight and dust
4 Your FC-4046 Video MultiCoder®
Figure 1 illustrates the front and rear panels of the FC-4046. Table 1 and
Table 2 define the front and rear panels of the FC-4046, respectively.
1 When the fifth dipswitch, AUTO, is set to ON for the multi-standard
2 Only supporting actions that are capable of performance. For example, you cannot convert the PAL standard to NTSC
3 Note that this unit does not scale or scan convert the signal. For example, a PAL input would produce 50Hz interlaced
output on the RGB output