Kramer Electronics SP-14 User Manual

Page 4

Advertising
background image

1 Introduction

This manual details the protocol used to remotely control your SP-14 image processor, where pseudo
code clarifies the protocol that has been included.

2 Communication Ports

The AV API protocol provides remote control functionality of units via RS232 and Ethernet.

2.1

RS232

The RS232 port is a 9-pin female connector. It is a three wire connection: RX, TX and ground.

The unit has the following serial port settings:
baud rate

9600

parity

none

data bits

8

stop bits

1

2.2

Ethernet

The ethernet connector is a RJ45 and runs at 10Mb/s.

To connect using ethernet the following settings are required.
IP Address

User Selectable / from DHCP

Subnet Mask/Extended Network Prefix

User Selectable / from DHCP

Port Number

30001


The user may choose to obtain the IP Address, subnet mask and extended network prefix from DHCP
or set them statically using the front panel (or GUI when available). The factory default is to obtain
them from the DHCP server.

2.3

Timing Constraints

After sending the request packet and before receiving the reply packet it is necessary to have a delay.
The following table provide a list of delays for specific parameters. For parameters not in the table the
delay should be 10 milliseconds. Failing observe this wait may have adverse effects on the unit,
causing lock-ups and data corruption requiring at least a power cycle and possibly a factory reset.

Parameter Identifier

Delay

avPar_pan

250 ms

avPar_tilt

250 ms

avPar_zoomX

250 ms

avPar_zoomY

250 ms

avPar_outputWndEdgeLeft

250 ms

avPar_outputWndEdgeRight

250 ms

avPar_outputWndEdgeTop

250 ms

avPar_outputWndEdgeBottom

250 ms

avPar_aspectRatioWidth

10 ms

avPar_aspectRatioHeight

10 ms

avPar_outputPictWarpTLX

250 ms

avPar_outputPictWarpTLY

250 ms

avPar_outputPictWarpTRX

250 ms

avPar_outputPictWarpTRY

250 ms

avPar_outputPictWarpBLX

250 ms

avPar_outputPictWarpBLY

250 ms

avPar_outputPictWarpBRX

250 ms

avPar_outputPictWarpBRY

250 ms

avPar_saturation

50 ms

avPar_hue

50 ms

avPar_chCurr_pipPosX

50 ms

avPar_chCurr_pipPosY

50 ms

Advertising