Kramer Electronics TP-126-od - Manual (Page 8)

The PT-110-od / TP-120-od Transmitter / Receiver Set
5
4 The PT-110-od / TP-120-od Transmitter / Receiver Set
The Kramer Pico TOOLS PT-110-od is an XGA line transmitter that receives
an XGA signal (up to UXGA), converts it to a twisted pair signal, and
transmits it over a CAT 5 cable to the Kramer TOOLS TP-120-od receiver
which converts it back to an XGA signal. Together the PT-110-od and
TP-120-od form a computer graphics transmitter/receiver system.
The transmitter receiver system has an operating range of more than 300ft
(more than 100m) using standard CAT 5 cable, has the Power Connect
feature
1
and is 12V DC fed.
The PT-110-od is pre-programmed with default EDID settings with EDID
information ready for the source even before capturing the EDID from the
display. When the PT-110-od is connected to a display device and the EDID
CAPTURE button is pressed, the PT-110-od reads and stores the EDID
(Extended Display Identification Data) from the display device. The display
can be disconnected and later reconnected without rebooting the operating
system.
The TP-120-od includes EQ. and LEVEL controls.
1 Powering via the CAT 5 cable from either the receiver or the transmitter is good for 50 meters. Above it, both sides should
be fed with power