Kramer Electronics TP-45EDID - Manual (Page 15)

12 TP-45EDID - Connecting a Component/XGA – Audio Distribution System
2. On the TP-45EDID, use the SELECT buttons as follows:
 Momentarily press the VIDEO SELECT button. The UXGA LED turns
off when the component video input is selected

Momentarily press the AUDIO SELECT button to toggle between the
S/PDIF and analog audio inputs
3. On the TP-46N, connect the following:
 The Y, C B /P B , C R /P R RCA connectors to a component video acceptor
(for example, a plasma display)

The S/PDIF RCA connector to the digital audio acceptor (for example,
the audio input on the plasma display)
4. Connect the LINE OUTPUT RJ-45 connector on the TP-45EDID to the LINE
IN RJ-45 connector on the TP-46N, via CAT 5 cabling, see Figure 5 .
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both theTP-45EDID and the TP-46N (not
shown in Figure 3 ).
The signal from the component video source is transmitted via the CAT 5
cable; decoded and converted to component video and outputted on the Y,
C B /P B , C R /P R OUTPUTS RCA connectors to the component video acceptor.
6. Connect the LINE OUT RJ-45 connector on the TP-46N to a second TP-46N
unit (optional).
7. If required, connect the LINE OUT RJ-45 connector on the TP-46N to
additional TP-46N units.