RADWAG MYA 5.3Y.F1 Microbalance - Manual (Page 112)

- 112 -
it is the 1 measuring cycle type B, and <3> means, that the <NUMBER OF
REPETITIONS> for this process is set to <3> (3 cycles).
Remember, that the software requests to carry out the <FIRST> cycle out
of <3> from all samples in a series, for which this measurement is
available (a condition is competing Weighing A for the sample).
During process course the bottom bar and the workspace display data on
the following steps that a user should follow.
In case tare is assigned to a sample, then its value is indicated on the
displayed with minus sign.
Place a sample on balance’s weighing pan (if tare is applied, then place a
sample into the container) and press <
> key.
On pressing the above key, a window is displayed for inserting ambient
temperature and humidity value – if option <Ambient conditions> is set to
<VALUE>, or the data on ambient conditions is automatically acquired from
the ambient conditions module and displayed for confirmation – if option
<Ambient conditions> is set to <ONLINE>.
Caution:
If option <Ambient conditions> in the working mode is disabled – set to
<No>, the software skips this part of the process.
On accepting the ambient conditions by pressing < > key, the software
returns to the mode’s main window and displays a command on unloading
the sample from the weighing pan (displayed in the message bar).
The user should unload the sample from balance’s weighing pan and accept
the activity by pressing <
> key.
The software automatically moves to the following sample in a series.
Follow above procedure and weigh the following samples.
The process can be aborted by pressing < > key.
On completing measurements of final mass for the samples in a series, the
user can check the results in the database of series.
To check the results, enter the database of series and select a series, then a
sample and a specific sample for which <Weighing B> has been carried out.