RADWAG WPW 60/H5/K Multifunctional Scales - Manual (Page 125)

Selecting the LABELLING operation mode is confirmed by continuous
displaying
► pictogram in the right edge of the display.
24.9.12. Description of labelling procedure
Notice:
Before the labelling procedure please design and load the pattern of the
label into the terminal memory. Chapter 32.3 of the manual presents the
example of creating and downloading the label into the terminal memory
and setting printer basic parameters to cooperate with the scale.
Procedure:
• After sending the pattern of the label to the terminal memory please
start mode LABELING following ch. 24.9.11 of the manual
• Edit data base: operators, products, contractors,
• Set appropriate parameters for labelling,
• Start to weight products following the weighing procedure
(see Chapter 12. WEIGHING),
• The label is printed on the printer after the key
is pressed.
In the bottom line there is the weighing number N and total mass
of weighings SUM,
• If the same products are still going to be weight (product is not
changed) after the scale shows zero (or after its zeroing) please put
next load on the scale. After the weight is stable press the key ,
• If different products are going to be weight press the key
, select
assortment and confirm it with the key ,
• Following labelling procedure is the same as the one shown above.
- 125 -