Autostart AS-2350vTW-FM - Manual (Page 10)

P. 10 User Guide
(this will bypass Turbo Mode).
D. TRUNK TO SET THE VEHICLE INTO IDLE MODE
Engine Run Time
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Extended Run Time
With the vehicle running under a remote start, pressing and holding the START/ STOP button for more
than 3 seconds will reset the run time counter to zero and restart the run time cycle from the
beginning.
To stop the vehicle, at any moment, simply press the
START/ STOP button. This procedure can only
be carried out once per remote start.
Example: if your Module is programmed for a run time of 3 minutes and your vehicle has been
running for 2 minutes already, pressing the
START/STOP button will reset the counter to zero and the
Engine will run for another cycle (in this case, 3 minutes).
Constant While Pressed
If enabled and if your vehicle is compatible, this option allows you to open or close your windows at
a distance, open or close the sunroof or even to open or close a sliding door:
• Pressing and holding the
LOCK button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the LOCK button is held down (maximum of 15 seconds). This
constant pulse can be configured to activate certain functionalities such as rolling up the
windows – Please refer to your installer to see if your vehicle is compatible with this
option.
• Pressing and holding the
UNLOCK button for more than 3 seconds will unlock all doors and will
send a constant pulse as long as the UNLOCK button is held down (maximum of 15 seconds).
This constant pulse can be configured to activate certain functionalities such as rolling down the
windows – Please refer to your installer to see if your vehicle is compatible with this
option.
Horn Chirp Timing
The pulse duration can be configured by your installer (from 5 ms to 200 ms).
Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, press and hold the
LOCK and UNLOCK buttons for 3 seconds:
• Flashing LED
ON : the L.E.D. will flash at all times (either under active arming or under passive
arming) to indicate that the starter kill is active.
• Active Arming: the LED will flash normally.
• Passive Arming: the LED will not flash during the countdown preceding the activation of
the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate.
• Starter kill ON/Alarm OFF: The LED will keep flashing twice quickly until the OEM
alarm is armed. Once the OEM alarm is armed, it will flash at a slower rate.
• In Valet Mode: the LED will remain lit without flashing.
• Flashing LED
OFF : the LED will not flash even when the module is armed (either under active or
passive arming). Nevertheless, if the module enters valet mode, the LED will still remain lit
without flashing as long as the ignition is off.