Autostart AS-2350vTW-FM - Manual (Page 8)

P. 8 User Guide
Ignition-controlled Door Locks
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically be locked as soon as the ignition key is
turned to the
IGNITION ON (RUN) position while the brakes are pressed. When the key is turned to the
OFF position, the doors will automatically be unlocked.
Ignition Re-lock
On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the
ignition key is in the
IGNITION ON (RUN) position, should any door be unlocked and opened, all doors
will be relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory
security system. The Secure Lock feature may be required on certain vehicle models with factory
security systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.
Remote Trunk Release
If your system was installed with the remote trunk release option, you can open your trunk by
pressing the
TRUNK button for 3 seconds. The OEM alarm will be disarmed until the LOCK button is
pressed.
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill
option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the
CRANK position.
Safe Start
If this feature is enabled, the user must press the START/STOP button 2 times within 3 seconds to
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
1. Press and release the
START/STOP button.
The parking lights will turn on.
2. Within 2 seconds of the parking lights turning on, press and release START/STOP again (before
the parking lights turn off).
If Swap Start Mode is selected, to remote-start your vehicle press
SHIFT and then LOCK . The AUX 2
output can be activated by pressing the START/STOP button.
Installer-Programmable Valet Modes
Valet Mode Using the Valet Switch (if installed)
To put the system i n t o Valet Mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Within 3 sec., press the valet button, the parking lights will flash three times and the
L.E.D. will come on solid once the ignition key is removed.
To take the system o u t o f Valet Mode:
• Turn the ignition key to the IGNITION ON (RUN) position.