Hyperterminal setup – Cirrus Logic EDB9302A User Manual
Page 33
Advertising
EDB9302A
Technical Reference Manual
DS653DB1
©
Copyright 2006 Cirrus Logic, Inc.
33
HyperTerminal Setup
Run the HyperTerminal program and configure to use COM1 and to run at 57600 baud, 8 data
bits, no parity, one (1) stop bit (8-N-1) and NO hardware control flow. It should look like the
picture below when complete. Note you have to "Disconnect" in order to make configuration
changes. Click "Call" once the configuration is complete.
Advertising