Hogtunes 692.2 / Lids Complete with 6 x 9 Speakers - Manual (Page 2)

Thank-you for choosing the Hogtunes Model 692.2/Lid kit! Since positive
word of mouth is the best way to grow our business, we want your new sys-
tem to work as well as it was designed to. If you have any questions or con-
cerns, we are here to help. Email [email protected], or call us during
regular business hours (EST) at 705-719-6361. If you still need help, please
consider a professional installation by your motorcycle dealer.
Important: The speakers in this kit are 2 ohms (2 Ω) and require an amplifier
capable of reliably playing this load. If using an amp other than Hogtunes,
please consult the manufacturer to make sure the amp you plan to use is 2
ohm stable! We strive to make the parts perfect, but things can happen.
Please inspect the parts carefully BEFORE paint!
Preparing the lids for paint:
Start by removing the 2 screws on the underside of the lid that se-
cures the grill in place. Lift up slightly on the grill and slide out.
From the magnet side, carefully remove the 2 small wires attached to
the woofer that go out to the tweeter.
Remove the 4 screws that secure the woofer to the lid and, and put
the woofer aside.
Remove the 2 screws that secure the tweeter bridge to the lid and re-
move. Note: there is a small rubber piece as shown in the circle be-
low. This seals the wires for the tweeter pod so please take extra care
not to lose this part.
NOTE: Do not paint the tweeter bridge! The tweeter is perma-
nently attached to the tweeter bridge assembly to make sure noth-
ing obstructs the built in drainage. In the event of warranty,
Hogtunes replaces the tweeter and the bridge as one piece, and
therefore assumes zero responsibility for paint!
2
Final Notes (Please Read):
The speakers magnet is large, and powerful. Credit cards and electronics can
be sensitive to magnets, so please exercise caution in how you pack your sad-
dlebags. Metal objects packed into your bags may end up stuck to the magnet,
so please use caution when opening the lids.
The magnet can get hot. Please consider this when packing your saddlebags.
The speakers magnet is covered by a rubber boot. This makes it look cool, but
is really there to help protect things inside the saddlebag that may bounce into
the magnet.
The woofer portion of the 6x9 was designed to work best with saddlebags
empty, or near empty..
Warranty Information:
Hogtunes speakers are warranted for a period of 20 years to the original pur-
chaser. The saddle bag lids are warranted against defects out of the box only.
Proof of purchase is required for all warranty claims. All Warranty claims
must be made through the dealer this product was originally purchased from.
Speakers found to be defective during the warranty period will be repaired or
replaced (with a product deemed to be equivalent) at Hogtunes sole discretion.
Amplifiers will be repaired
What Is Not Covered:
1)Any expense related to the removal or re-installation of Hogtunes products.
2)Repairs to these products performed by anyone other than Hogtunes.
3)Subsequent damage to any other components.
4)Any product purchased from a non-authorized Hogtunes dealer.
5)Damage to Hogtunes products due to an accident or collision.
6)Paint applied to any part, for any reason
7) Speaker frames (baskets) that are bent
8) Speaker cones that are pierced or cut.
Technical Specifications:
Hogtunes #692.2-AA Speakers
Power Handling: 200 Watts
Frequency Response: 30hz-25Khz
Sensitivity : 96 db 1watt/1meter
Nominal Impedance: 2.0 Ohms
7
Don’t lose the rubber part!