MSI H61MA-E35 (B3) - Manual (Page 27)

2-13
Hardware Setup MS-7740
Chapter 2
Fan Power Connectors: CPUFAN,SYSFAN
The fan power connectors support system cooling fan with +12V. When connecting the
wire to the connectors, always note that the red wire is the positive and should be con-
nected to the +12V; the black wire is Ground and should be connected to GND. If the
mainboard has a System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take advantage of the CPU fan control.
1.Gro
und
2.+1
2V
3.Se
nsor
1.Gro
und
2.+1
2V
3.Se
nsor
4.Co
ntrol CPUFAN SYSFAN
Important
• Please refer to the recommended CPU fans at processor’s official website or consult
the vendors for proper CPU cooling fan.
• CPUFAN support Smart fan control. You can install Control Center utility that will
automatically control the CPUFAN speeds according to the actual CPUFAN tem-
peratures.
• Fan cooler set with 3 or 4 pins power connector are both available for CPUFAN.
Front Panel Connector: JFP1
This connector is for electrical connection to the front panel switches and LEDs. The
JFP1 is compliant with Intel ® Front Panel I/O Connectivity Design Guide.
1.+
3.-
10
.N
o
Pin
5.-
R
es
et
Sw
itc
h
H
D
D
LE
D
Po
w
er
Sw
itc
h
Po
w
er
LE
D
7.+
9.R
es
erv
ed
8.-
6.+
4.-
2.+