MSI H61MA-E35 (B3) - Manual (Page 41)

3-9
BIOS Setup MS-7740
Chapter 3
▶Hardware Monitor
Press <Enter> to enter the sub-menu.
▶CPU Smart Fan Target
The Smart Fan function controls the CPU fan speed automatically depending on the
current temperature to keep it with in a specific range. You can enable a fan target
value here. If the current CPU fan temperature reaches to the target value, the smart
fan function will be activated.
▶SYS Fan 1 Control
These items allow users to select how percentage of speed for the SYSFAN1.
▶CPU/ System Temperature, CPU FAN/ SYS FAN 1 Speed, CPU Vcore Voltage,
CPU IO Voltage, DRAM Voltage, GPU Voltage, 3.3V, 5V, 12V
These items show the current status of all of the monitored hardware components
such as CPU/ system temperatures, all fans’ speeds and voltages.
▶Power Management Setup
Press <Enter> to enter the sub-menu.
▶EuP 2013
This item is designed for Energy Using Products Lot 6 2013 (EuP) aka Energy
Related Products (ErP). To reduce Power Consumption when system off or standby
mode.
Note: When “Enabled” EuP 2013 setting, system don’t support RTC wake up event
function.
▶Restore on AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Power Off] Always leaves the computer in the power off state.
[Power On] Always leaves the computer in the power on state.
[Last State] Restore the system to the status before power failure or interrupt
occurred.