Nostalgia Electrics KRS6100 SERIES - Manual (Page 11)

E
N
G
LI
S
H
9
INSTALLING THE CASTERS
Follow the steps below to install the Casters.
Note: Two of the Casters include locking mechanisms to ensure the unit does
not slide on hard floors. These two locking Casters should be fastened at the
front end of the unit, with the unlocked Casters fasted on the rear end.
1. Empty the inside of the cabinet completely
and lay the DOUBLE KEGORATOR™ down
on it’s side. We recommend that you place
a piece of cardboard or cloth underneath
the cabinet to prevent dents or scratches.
2. Place washers over Caster bolts, then
insert the Casters into the holes on the
bottom corners of the cabinet. Tighten
each Caster by turning the nut clockwise
with a wrench (not provided in the kit).
3. Once all four Casters have been tightened,
stand the cabinet in its upright position.
INSTALLING THE GUARDRAIL
Follow the steps below to install the Guardrail.
1. Place the Guardrail on top of
the DOUBLE KEGORATOR™.
2. Align all holes of the Guardrail with the holes
on the top of the DOUBLE KEGORATOR™.
3. Secure the Guardrail to the
DOUBLE KEGORATOR™ by placing
inside corresponding holes.