Nostalgia Electrics KRS6100 SERIES - Manual (Page 13)

E
N
G
LI
S
H
11
STEP 6
The CO2 Rubber
Directional
Washers go
back into the
Keg Couplers.
STEP 7
Connect the
CO2 lines from
the Double
Regulator to the
Keg Couplers.
STEP 12
After the Tap Tower has been placed on
the DOUBLE KEGORATOR™ and the hose
lines feed through the bottom, attach
the wing nuts to the Keg Couplers.
STEP 8
Place the Beer Tower Washer (#5) over the
hole. Place the Tap Tower on the DOUBLE
KEGORATOR™ and feed the hose lines through
the hole in the top of the DOUBLE KEGORATOR™.
STEP 10
Make sure the Tap Tower is securely
screwed into the top of the DOUBLE
KEGORATOR™. It should look like the image
above when installation is complete.
STEP 11
Place Coupler Washers (#3) on
top of the Keg Couplers.
STEP 9
Screw in the four screws using a
Phillips Head or Flat Head screwdriver.
Screws are located in the bag
containing extra parts and washers.