Tapping the beer keg, How to operate, En g li s h – Nostalgia Electrics KRS6100 SERIES User Manual

Page 15

Advertising

TAPPING THE BEER KEG

(SINGLE VALVE-TYPE KEG)

Follow these steps below to tap the Beer Keg.

Make sure the black pull handle of the Keg Coupler is in the closed (up)

position before installing it on the keg (Fig. 1). Insert the Keg Coupler into

the locking neck of the Beer Keg and turn clockwise until it locks into

position (Fig. 2). This means that it is secured to the Beer Keg.

Make sure the Beer Tower Faucet is in the closed (handle pointing straight back) position

before connecting the Keg Coupler to the Keg (Fig. 3). To secure

the tank connection, pull the Keg Coupler handle out and push down until it locks into

position. Listen for the “click” of the pull handle when it shifts into the final downward

position (Fig. 4). This will open the beer and CO2 gas valves. The Keg is now tapped.

Carefully tilt the Keg and rest the edge on the Keg Base Board on the

bottom of the Interior Cabinet. Slide the Beer Keg slowly, ensuring

that it is properly located (Fig. 5) and carefully close the door.

HOW TO OPERATE

Follow the steps below to dispense beer.

Make sure that the DOUBLE KEGORATOR™ is plugged in properly

to a 120V, 60Hz, 15 Amps grounded AC outlet.

Place the Drip Tray under the Beer Faucet to avoid messes from excess beer.

Open the Beer Faucet by pulling the tap towards you to dispense the beer. If for any reason

the beer does not come out of the tap, please refer to the Tapping the Beer Keg section.

Increase the pressure if the beer runs too slowly (see Regulator section).

Hold the glass steady at a 45° angle. When it is ²

/ 3

full, straighten the

glass. Proper foam should be a tight creamy head and the collar

on an average glass should be ¾” to 1” high, ideally.

fig. 4 fig. 5

fig. 1 fig. 2

fig. 3

Black pull handle

Connect to the
Beer Line Tube

Connect to
CO2 Gas
Line Tube

Keg Coupler

OCKWISE

Beer Keg Neck

Keg Support

Beer Keg

Lift Upright