Seiwa Tigershark Plus - Manual (Page 24)

26 User Manual
MARLIN:
[TRACK] + "CONFIG" + [ENTER] + "DISPLAY MODE" + [ENTER] + "VIS-
IBLE"/"HIDDEN" + [ENTER]
Activating/Deactivating Track Recording
To activate or deactivate the Tracking of the vessel while the vessel is moving:
[MENU] + [MENU] + "TRACK" + [ENTER] + "ACTIVATE"/"DEACTIVATE"
+ [ENTER]
MARLIN:
[TRACK] + "ACTIVATE"/"DEACTIVATE" + [ENTER]
Clearing Track
All the Track or part of it can be cleared from the screen:
[MENU] + [MENU] + "TRACK" + [ENTER] + "DELETE" + [ENTER]
MARLIN:
[TRACK] + "DELETE" + [ENTER]
[B
EGIN
], [E
ND
] and [W
HOLE
] allow to identify the start or the end point of the seg-
ment to delete.
Selecting Track Number
The chart plotter has the capability to store up to 5 Tracks. To select a Track:
[MENU] + [MENU] + "TRACK" + [ENTER] + "CONFIG" + [ENTER] + "ACTIVE
TRACK" + [ENTER] + use the cursor key to select the number + [ENTER]
MARLIN:
[TRACK] + "CONFIG" + [ENTER] + "ACTIVE TRACK" + [ENTER] + use the
cursor key to select the number + [ENTER]
TRACK TO ROUTE FUNCTION
This function creates a Route from a pre-recorded Track. To select this menu:
[MENU] + [MENU] + "TRACK" + [ENTER] + "TRACK TO ROUTE" + [ENTER]
MARLIN:
[TRACK] + "TRACK TO ROUTE" + [ENTER]
A new window appears on the screen with the following options.
Track To Route
Executes the function that converts the given Track into a Route.
[MENU] + [MENU] + "TRACK" + [ENTER] + "TRACK TO ROUTE" + [ENTER] +
"TRACK TO ROUTE" + [ENTER]
MARLIN:
[TRACK] + "TRACK TO ROUTE" + [ENTER] + "TRACK TO ROUTE" + [ENTER]
Advanced menu
Allows setting the parameters used by the function Track To Route.
[MENU] + [MENU] + "TRACK" + [ENTER] + "TRACK TO ROUTE" + [ENTER] +
"ADVANCED" + [ENTER]
MARLIN:
[TRACK] + "TRACK TO ROUTE" + [ENTER] + "ADVANCED" + [ENTER]
A new window appears on the screen. The possible choices are listed in the table
below:
Select Track No. : Selects the Track input number.
Select Route No. : Selects the Route output number.