Argox OS-214 plus - Manual (Page 7)

8
Control /
Indicator
Function
Power Switch
• On: power on
• Off: shut down
Note: Turn power off before connecting or
disconnecting cables
Power Indicator
• Green light shows the power-on status
• Light off shows the power-off status
• Blinking light indicates error has occurred
Ready Indicator
• Green shows printer is ready to operate
• Blinking light indicates printer is paused or
data transferring
• Light off indicates pack flash is under
processing
Feed Button
• Press to advance labels to the first printing
position
• Press to leave "pause" status
• Press to back feed if a label is not properly
aligned
• Press and hold while turning on the power
to print out a configuration profile
9
Loading Ribbon and Media
This section describes how to load ribbon and media
into the
OS-214 plus printer.
Loading a Ribbon
Note: This section does not apply to direct thermal printing.
1. Lift the top cover to expose the media compartment.
2. Unlatch the print head module by pushing the two white
release levers on the sides toward the rear.
3. Turn over the print head module to expose the ribbon
supply holder.