Vollrath Affordable Portable Hot Food Station Operator Manual - Manual (Page 6)

A
ffordAble
P
ortAble
b
uffet
e
quiPment
O
peratOr
’
s
M
anual
6
t
rouBleShooting
Problem It might be caused by Course of Action
Switch does not light up when in the “ON”
position.
Unit is not plugged in. Plug unit in.
Unit does not get to correct temperature or
to a high temperature.
Low or incorrect voltage to unit. Verify that voltage rating in unit matches the source voltage. If not
have qualified electrical personal install proper source voltage.
No water or incorrect water level. Add water to correct level.
S
ervice and
r
ePair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the unit or replace a damaged power cord
yourself. Do not send units directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
VOLLRATH Repair Service • 1-800-628-0832
When contacting the Authorized Professional Service Center, please be ready with the model number, serial number, and proof of purchase showing the date
the unit was purchased.
c
leaning
To maintain the appearance and increase the service life, clean your induction
range daily.
WARNING
Burn Hazard.
Do not touch heating surfaces, liquid, or food while
unit is heating or operating.
Hot food, steam and liquids can burn skin. Allow the hot liquid,
spillage pans and trays to cool before handling. Use gloves, mitts or
pot holders if it is necessary to handle hot pans.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock.
1. Turn off and unplug the unit.
2. Begin cleaning after hot well units have completely cooled or cold well
units have been drained.
3. Wipe the unit exterior with a clean damp cloth.
4. Do not use abrasive materials, scratching cleansers or souring pad to
clean the unit. These can damage the finish.
5. Thoroughly wipe off any mild soap or chemical cleaners. Residue
could corrode the surface of the unit.