Vollrath CF101 User Manual
Page 15
9
NOTE
The United States Department of Agriculture and
the Food and Drug Administration require that lu-
bricants used on food processing equipment be cer-
tified for this use. Use lubricants only in accordance
with the manufacturer’s instructions.
A.
Coat the rear seal with a generous amount of
Petrol Gel.
B.
Install the rear seal onto the auger.
C.
Lubricate the auger drive (rear) with a small
amount of white socket lubricant. A small container
of socket lubricant is shipped with the machine.
D.
Install two of the springs and auger blades onto the
rear of the auger and insert part way into machine
barrel. Rotate auger so another spring and blade
can be placed onto the shaft.
E.
Install the remaining auger blades, push the auger
into the machine barrel and rotate slowly until the
auger engages the drive shaft (Fig. 3-6).
F.
Lubricate the inside and outside of the front wear
bushing and install it onto the auger (Fig. 3-7).
To disassemble the machine, refer to the following steps:
CAUTION
Hazardous Moving Parts
Revolving auger shaft can grab and cause injury.
Place the Main Freezer Power OFF-ON switch in
the OFF position before disassembling for cleaning
or servicing.
A.
Remove the flow control rod and flow control
valve from the hopper by pulling straight up.
C.
Remove the slide from the faceplate and remove
the faceplate.
D.
Remove the front wear bushing.
F.
Remove the auger assembly from the machine.
Pull the auger out of the freezing cylinder slowly.
As the auger is being pulled out, carefully remove
each of the blades and springs.
G.
Keep the rear of the auger shaft tipped up once it
is clear of the machine to avoid dropping rear seal.
H.
Remove the rear seal, rear seal adapter and rear
seal o-ring.
I.
Wipe socket lubricant from the drive end (rear) of
the auger with a cloth or paper towel.
3.9 CLEANING THE MACHINE PARTS
Place all loose parts in a pan or container and take to the
wash sink for cleaning. To clean machine parts refer to the
following steps:
A.
Prepare detergent water by mixing 2 oz. of
Palmolive detergent or equivalent in 2 gallons of
90° to 110°F (32° to 43°C) water.
B.
Place all parts in detergent solution and clean with
provided brushes.
C.
Wash the hopper and freezing cylinder with the
detergent water and brushes provided.
D.
Wash the rear seal surfaces on the inside of the
freezing cylinder with the detergent water.
E.
Rinse all parts with clean 90° to 110°F (32° to
43°C) water.
NOTE
If the machine is not going to be immediately oper-
ated, store the faceplate in a clean and sanitized
container in a cooler.
3.10 ASSEMBLY OF MACHINE
To assemble the machine parts, refer to the following steps:
NOTE
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specified.
Figure 3-6 Installing Auger Blades
Figure 3-7 Install Front Wear Bushing