Kodak DC40 - Manual (Page 37)

33 January 1996
Connecting to a Computer Running
WINDOWS Software
Your personal computer contains either a 9-pin or a 25-pin serial port.
The cable supplied with the DC40 camera uses a 9-pin connector,
therefore, you will need to use the adapter provided with the camera if
you want to use a 25-pin serial port.
IMPORTANT: Use only the cable provided with the DC40 camera.
1. Turn off the camera by sliding the lens cover switch to the OFF position.
2. Attach the 9-pin adapter to the 25-pin port IF your personal computer
uses a 25-pin serial port.
3. Plug the matching end of the cable into the serial port or adapter on
the back of your computer.
4. Tighten the connector’s thumbscrews.
5. Lift the rubber tab to uncover the camera’s serial port.
6. Plug the unused end of the cable into the camera’s serial port after
carefully lining up the notches.