AT&T ID-282H - Manual (Page 11)

EN
10
PROBLEM
Unable to make
a call -
OUT OF RANGE
appears on the
handset
Unable to make a
call -
NOT REGISTERED
appears on the
handset
Unable to enter the
submenus
Caller ID is not
displayed
POSSIBLE CAUSES / REMEDIES
• The handset is out of range of base
unit - move closer to the base
• Interference due to environment - position base
unit to reduce interference (move higher)
• De-synchronization has occurred. The base
unit will reset synchronization automatically.
• Handset may not be registered to base unit
(see the section in this manual titled
HANDSET REGISTRATION ).
• Ensure unit is not in the base cradle.
• Return to standby mode by pressing
• You must subscribe to Caller ID service
through your local phone company for this
feature to work. Contact your local phone
company to confirm you have subscribed to
Caller ID service.
• Wait until the phone rings twice before
answering.
• Full name and number (including area code )
need to be stored in Phonebook for name
display if the name is unavailable through
Caller ID.
TROUBLESHOOTING
See below for some common problems and their remedies. Whatever
the problem, you should first check that:
• The base unit is connected to the power supply and phone line.
• The main power is switched on at the electrical outlet.
• The handset battery is installed and has not run out of power.
DO NOT attempt to make repairs yourself. This will void your warranty.