Lenovo IdeaPad U310 User Manual
Page 44
Lenovo IdeaPad U310/U410 U310/U410 Touch Hardware
Maintenance Manual
40
Figure 1. Removal steps of battery pack (continued)
The illustration below is the design sketch of Area B.
Area C: Take a rectangular absorber (50mm wide x 45mm high) and a black
Mylar (50mm wide x 20mm high - the height may vary), and adhere them to each
other as follows.
Note:
The adhesive sides of the black Mylar and the absorber should face the
same direction.
Area C: Take the treated absorber as shown in the illustration above, and apply
it to the machine from the blue baselines pointed to by the blue arrows in the
illustration below. When the starting positions are fixed, press the absorber to
make it flat.
Note:
The yellow area in this illustration corresponds to the location of the black
Mylar on the absorber.
adhesive side
adhesive side