Lenovo IdeaCentre A530 - Manual (Page 66)

Step 4. Remove the base cover. Refer to “Removing the base cover”.
Step 5. Remove the hinge from the chassis. Refer to “Removing the hinge from the chassis”.
Step 6. Remove the rear cover. Refer to “Removing the rear cover”.
Step 7. Disconnect the power cable from the power switch board.
Step 8. Remove the screw that secures the power switch board to the LED panel and lift up the power
switch board to remove it.
Step 9. To install the power switch board:
a. Line up the hole on the new power switch board with the mounting hole on the LED panel and
secure it with the screw.
b. Connect the power cable to the new converter board.
Step 10. Reattach the rear cover to the LED panel.
Step 11. Reattach the hinge to the chassis, and reconnect the scalar headphone input, scalar and DVI/HDMI
cables to the motherboard.
Step 12. Reattach the base cover and secure it with the screws.
Replacing the Bluetooth module
Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the base cover.
To replace the Bluetooth module:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.
Step 4. Remove the base cover. Refer to “Removing the base cover”.
Step 5. Remove the hinge from the chassis. Refer to “Removing the hinge from the chassis”.
60 IdeaCentre A530 All-In-One PC Hardware Maintenance Manual