Lenovo Secure Managed Client User Manual
Page 52
9.
Type diskpart. This will start the diskpart command line application
10.
Type list volumes. This will list all the volumes that diskpart sees.
You should see three volumes:
a.
C:
this is your operating system volume from your local hard drive on
your client.
b.
D:
this is the data volume from your local hard drive on your SMC client.
c.
RAW volume:
the storage array Base Image created in step 1 on page 43.
11.
Type list disk. You should see disk 0 (local hard drive) and disk 1 the storage
array Base Image created in step 1 on page 43)
12.
Type select disk 1. This will select the storage array Base Image created in step
1 on page 43.
13.
Type Create partition primary size=n where n is the size of the operating system
partition to create in the Base Image. This will create the operating system
partition within the Base Image.
14.
Type Create partition extended. This will create the extended data partition with
the space left in disk 1.
15.
Type Create partition logical. This will specify that data partition into a logical
partition
16.
Type Format fs=ntfs label=”data” quick. This will format disk 1 as NTFS.
17.
Type Assign letter=g. This will assign a temporary drive letter to the data
partition.
18.
Type xcopy d:\ g:\ /s /h /e /y /q. This will copy all data from the d: drive on
your local hard drive to the data partition on the storage array in the Base
Image space. This will take several minutes since it is a binary copy of all data
on your d: drive.
19.
When you finish, click the Restart Wizard button. This will restart the wizard
to allow for a copy of the c: drive
20.
Click on select local drive.
21.
Select the C: partition.
22.
Select Disk 1 to copy to.
23.
Check box to select partition on disk 1.
24.
Check partition 1 where the operating system partition should go.
25.
Click Next. This process will take some time to complete.
26.
When finished, your image is ready.
Copying a multiple partition image to the storage array,
Version 2.0
To allow for these multiple partitions to be copied from the local hard disk of a
Secure Managed Client client to the storage array for Version 2.0, do the following:
1.
Create the base image on the storage array using the Secure Managed Client
Management Console. That image will be in Pending state.
2.
Start the client with the image sysprepped to the hard drive to the ULOS
screen.
3.
Insert your own WinPE cd into the CD drive on the client.
4.
In the Secure Managed Client Management Console, left-click, hold and drag
the client machine to the base image in pending state. For example, drag a
client named LENOVO-L3A0426 down to the Test Base Image.
5.
The Boot SMC Client window opens. Select include cd-rom in the boot order
at the bottom of the window.
44
Secure Managed Client Version 2.0 Deployment Guide