Lenovo Horizon 27 Table PC IdeaCentre - Manual (Page 33)

Step 4. Place the computer face-down on a soft flat surface, then open the rubber cap as shown. 1
Step 5. Put the head of a flat head screwdriver between the front bezel and the rear cover as shown.
Then using the screwdriver as a lever and the front bezel as the fulcrum, prise the rear cover
away from the middle frame.
2 3
1 2 3
Step 6. Working around the edge in an clockwise direction, use your fingers to prise up the rear cover. The
rear cover is pinned into place, use short, sharp movements to prise it up.
Step 7. Then lift up and slide out the rear cover.
Step 8. To reattach the rear cover:
a. Line up the rear cover with the chassis, slide it back and snap it into position.
Chapter 8 . Replacing hardware 27