Lenovo C540 All-in-One - Manual (Page 53)

Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.
Step 4. Remove the stand base. Refer to “Removing the stand base”.
Step 5. Remove the foot cover. Refer to “Removing the foot cover”.
Step 6. Remove the optical drive. Refer to “Replacing the optical drive”.
Step 7. Remove the stand holder. Refer to “Removing the stand holder”.
Step 8. Remove the middle cover. Refer to “Removing the middle cover”.
Step 9. Remove the EMI cover. Refer to “Removing the EMI cover”.
Step 10. Remove the heat-sink. Refer to “Replacing the heat sink”.
Step 11. Remove the screw that secures camera to the front bezel.
Step 12. Lift up the camera and disconnect the data cable from the camera.
1
2
Step 13. Remove the two screws that secure the camera to the bracket, then put aside the bracket.
Step 14. To install the new camera:
a. Line up the new camera with the bracket, then secure the camera to the bracket with the
two screws.
b. Connect the data cable to the new camera.
c. Line up the holes in the new camera with the mounting holes on the front bezel and secure it
with the screw.
Step 15. Reattach the heat-sink, EMI cover, middle cover, optical drive, stand holder, foot cover and stand
base.
Replacing the CPU
Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
Chapter 8 . Replacing hardware 47