Lenovo IdeaCentre A700 - Manual (Page 40)

Hardware Maintenance Manual
38
7. Push out the latches on both sides of the memory socket to release
the memory module and gently pull the memory module upward to
remove it from its socket . Both memory modules can be removed by
using the same procedure.
8. Align then insert the new memory module into the socket and push
down on the top edge of the memory module. Make sure the latches
lock the memory module in place.
9. Align then install motherboard cover back.
10. Install the computer cover and stand.
Replacing connectors module
Attention
Turn off the computer and wait 3 to 5 minutes to let the computer
cool down before replacing the connectors module.
Note
For this procedure, it helps to place the computer face-down on a
soft flat surface. Lenovo recommends that you use a blanket, towel,
or other soft cloth to protect the touch screen surface from scratches
or other damage.
To replace the connectors module:
1. Remove any media (diskettes, CDs, or memory cards) from the drives,
shut down the operating system, turn off all attached devices, and the
computer.
2. Unplug all power cords from electrical outlets.
3. Disconnect all cables attached to the computer. This includes power
cords, input/output (I/O) cables, and any other cables that are
connected to the computer. Refer to “Locating connectors on the rear
of the computer”.
4. Remove the computer stand. Refer to “Removing the computer stand”.
5. Remove the computer cover. Refer to “Removing the computer cover”.