Lenovo C240 All-in-One - Manual (Page 51)

Step 11. The LED panel is pined to the front bezel. Pull the pins outward to release it 1 , then slide out
the LED panel out as shown. 2 3
1
2
3
Step 12. To install the new the LED panel:
a. Line up the new LED panel with the front bezel, then slide it into position.
b. Secure the LED panel to the front bezel with the 2 screws.
c. Attach all the cables to the new LED panel.
d. Reattach the converter bracket to the front bezel.
e. Reattach the converter board to the bracket.
f. A converter jumper setting is required after replacing the old panel with a new panel. Follow the
below diagram to insert the jumper heads to the pins properly depending on the panel brands:
PJP6
PJP7
Jumper Head s
Chapter 8 . Replacing hardware 45