Lenovo IdeaCentre Q200 - Manual (Page 46)

Hardware Maintenance Manual
44
4. press the release button to pull the drive and bracket out of the drive
bay by pulling on the blue handle.
5. Use the blue handle to remove hard disk drive from drive bay.
6. Slide the new hard disk drive into the drive bay.
7. Pivot in the drive bay in place.
8. Connect the power and signal cables to the hard disk drive. Refer to
“Identifying parts on the system board”.
9. Refer to the “Completing the installation”.
Replacing an optical drive
Attention
Do not remove the computer cover or attempt any repair before
reading the “Important safety information” in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of
the Safety and Warranty Guide or HMM, go to the Support Web site at
http://consumersupport.lenovo.com.
To replace an optical drive
1. Open the computer cover. Refer to “Opening the computer cover”.
2. Remove the front bezel. Refer to “Removing and replacing the front
bezel”.
3. Disconnect the signal and power cables from the rear of the optical
drive.