Lenovo IdeaCentre A520 All-in-One - Manual (Page 57)

Step 10. Reattach the rear cover to the LED panel.
Step 11. Reattach the hinge to the chassis, and reconnect the scalar headphone input, scalar and DVI/HDMI
cables to the motherboard.
Step 12. Reattach the base cover and secure it with the screws.
Replacing the touch control board
Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the base cover.
To replace the touch control board:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.
Step 4. Remove the base cover. Refer to “Removing the base cover”.
Step 5. Remove the hinge from the chassis. Refer to “Removing the hinge from the chassis”.
Step 6. Remove the rear cover. Refer to “Removing the rear cover”.
Step 7. Disconnect all the touch cables from the touch control board.
Step 8. Lift up the touch control board to remove it from the middle frame.
Step 9. To install the new touch control board:
a. Connect all the cables to the new touch control board.
b. Remove the insulating paper (siliconed paper) of the double sided tape on the new touch
control board.
Chapter 8 . Replacing hardware 51